ColorFabb Bronzefill 0.75 Kg

  • Sale
  • Regular price $59.95


What do you get when you cross Colorfabb PLA/PHA with fine bronze powder?

Bronzefill of course.

You can find the relevant data sheets Here

Printing Temp

195-220C°

Print Speed

40-100 mm/s

Heated Bed Temp

50-60C° (Heated bed not required) 

Diameter

1.75mm and 2.85mm

Diameter Tolerance

± .05mm

Density

3.9 g/cm3

Glass Transition Temp

55C°

Here are a few Tips from ColorFabb

TIP! Depending on your set-up, 3d printer and slice software, you might see that bronzeFill needs a bit more flow compared to your normal PLA settings. Most plastics will show die swell when coming out of the nozzle tip, this is counteracted with specific slicer settings. Since bronzeFill doesn’t show a die swell such as PLA you might need to increase flow rate a bit, 4-8% was perfect for our UM2. UM original did not need any adjustments.

TIP! Sanding and polishing your parts will make the bronze particles shine. Start sanding with grit 120-180 and make sure all the printed lines vanish. You’ll notice that because bronzeFill is easy to sand down, careful you won’t loose too much detail. Then start working your way up by following with grit 240-320 and finishing off with grit 600 - or higher. Finally we used a clean soft cloth and some copper polish to really get all of the shine out of the bronze particles.